Fully synthetic contact spray which is compatible with plastics and formulated for use on vehicle electronic and electrical systems. Contains no silicones or mineral, animal or vegetable based oils.
- cleans contaminated contacts
- good water separation
- good corrosion protection
- penetrates layers of oxides and sulphides
- drives out moisture
- reduces contact resistance
Base: synthetic oil
Density at 20 °C: 0,85 g/cm³ - DIN 51 757
Pour point: -53 °C - DIN ISO 3016
Flash point: 201 °C - DIN ISO 2592
Viscosity index: 145
Evaporation loss (Noack): 2,1 Gew.-% - DIN ISO 2909
Water content: 40 ppm Ω · cm - DIN 51 581
Neutralization number: 0,03 mg KOH/g - DIN 51 777 T 1
Copper corrosion: 0-1 - DIN 51 809
Specific electrical volume resistance at 20 °C: 1,6 · 10 ⁹ Ω · cm
Viscosity at 40 °C: >7 mm²/s
Areas of application
Used for the care and maintenance (cleaning and protection) of all electrical components on the motor vehicle such as plug and terminal connections, lamp sockets, cable distribution boxes, switch elements, relays, ignition distributors, contact breakers, starters, dynamos/alternators, fuses, battery terminals and antennae and for the lubrication of fine mechanical components.
Spray components before installing them. If the contacts are heavily corroded, allow the product to act for longer and rub off corrosion residues with a cloth or brush.
Note: After spraying on, allow a flash-off period of 10 min. before connecting the component to a power supply.